We maintain a limited stock of select used organs, suitable for complete renovation and relocation.

We are pleased to announce that the 1860 Willis Scudamore Peerage Organ we offered for sale has found a new home!

We are pleased to offer the following instruments at present.

Kindly contact

Keith Williams, Service Department Director


[email protected]



Wicks organ, Opus 5034, built 1970



2 ranks, Gedeckt/Koppel Flute & Gemshorn, voiced on 2” wind pressure


Main chest 84” wide x 24” deep + 36” for keyboards and pedalboard

Subbass chests presently installed on either side, adding 1’ each (could be installed behind)

Wooden pipes mitered to 88”, tallest Gemshorn pipe 89” floor to top of pipe


Pedal                                        Manual II                                 Manual I


16’ Subbass                             8’ Gemshorn                            8’ Copula

  8’ Gedeckt                             4’ Koppel Flute                        4’ Gemshorn

  4’ Flute                                  1-1/3’ Spitz Quinte                   2’ Block Flute


16’ Subbass CCC 5” x 7” cutup 2-1/2”

4’ Gemshorn C 2-3/4” at mouth 1-1/4” at top, 1-3/4” mouth width (bearded)



1883 Felgemaker organ


2 manual and pedal, 13 ranks + possible additions

A.B. Felgemaker mechanical action organ, Erie, PA

Opus 551, built 1886

Two manuals and Pedal, 13 ranks

Great – 61 notes

16’ Bourdon

  8’ Open Diapason      1-17 in façade, C1 = c.6-1/2”                                                                         

  8’ Melodia                 1-13 sw, 13-61 ow

  8’ Dulciana                 1-12 in façade

  4’ Octave                   1-6 in façade, c1= c.4-1/16”

  2-2/3’ Twelfth

  2’ Fifteenth

Swell – 61 notes

8’ Open Diapason        (1-13 from Stopped Diapason), C13 = 3-1/8”

8’ Stopped Diapason    1-61 sw

4’ Flute Harmonique

2’ Principal                   (originally an Aeoline)

8’ Bassoon                   1-12

8’ Oboe                       13-61

Pedal – 27 notes

16’ Bourdon

Swell to Great              Tremolo

Swell to Pedal              Bellows Signal (deactivated)

Great to Pedal              Pedal Check (deactivated)

Balanced Swell pedal in center of knee panel, cast with the letters “A.B.F.”
Unlabeled Great piano and forte combination pedals to left and right of swell pedal
Pitch A=440 at 3” w.p.
Total width of the instrument is c.140”.   The height from the floor to the top of the tallest façade pipes is 224.5”.  The height from the floor the tops of the “average” façade pipes is 206”.  The height from the floor to the top of the swell enclosure is 156”.  The depth of the instrument from the rear to the front of case is 122”, including a 10” walkboard at the rear of the Swell enclosure.   The console projects c.40” from the front of the case.   There are 35 pipes in the main façade of painted zinc, arranged in 3 flats 5-15-5. .  Pipes 1-10 of the Great 8’ Open Diapason were relocated from the façade to within the instrument.  They were originally located in side wings to the main case, and in their original position probably did not add to the total height of the instrument.
 From its construction in 1886 until its acquisition by Buzard Pipe Organ Builders in 2002, this organ served the congregation of Wesley Chapel Methodist Church in Cincinnati, OH.  That organ was moved to the congregation’s second home in 1973, at which time the configuration of the instrument was slightly altered. The impost and façade were taken off the main case and placed on the floor to the right of it.   The original winding system was replaced with a Spencer Orgoblo and three modern reservoirs. The original 27-note pedalboard was replaced with a modern 32-note one. 
 At the time of removal from the church, the organ was in good playing condition.  The instrument has been completely disassembled and inspected in our factory, and mechanical restoration is ongoing.  Before reinstallation, the following work will be performed.
 Windchests.  All four windchests (one Swell, one Great, and two Pedal) will be completely restored.  Note channels and sponsil areas will be flooded with glue.  New felt/leather coverings will be installed on the pallets.  New rubber cloth will be installed on the underside of the windchests.  Pallet springs will be renewed.  Chest top tables will be planed true.  Bearers will be checked for proper thickness and shimmed as appropriate.  Chest table top surfaces, sliders and toeboard bottoms will be graphitedRackboards and rack pillars will be cleaned, repaired, and refinished as necessary.
 Action.  All components of the stop and key action will be cleaned, repaired and lubricated as necessary.  Any broken or missing parts will be replicated.  All felted bushing points will be renewed.  All threaded brass wires will be inspected and cleaned, and replaced as necessary.  All new leather nuts and bushing cloth washers will be installed throughout the action.  The manual keyboards and pedalboard will be completely rebushed, with new key coverings as required.   A 27-note pedalboard in the style of the original will be fabricated and installed.
 Wind system.  The original reservoir was removed from the organ at some point in the past.  Buzard has acquired a Felgemaker reservoir of appropriate capacity and dimensions, which will be restored and installed within the base of the instrument.  The existing blower and enclosure can be retained, or a new, more silent blower can be provided.
 Pipework.  The zinc tuning scrolls on the 35 façade pipes will be cut out and replaced with new, felted spotted metal inserts soldered in place.  The collapsed toes on these pipes will be replaced with new cast lead toes.  All pipes will be cleaned.  Slide tuners will be checked for proper tightness and replaced as necessary.  Stopped pipes will have their stopper packing replaced.  All pipes will be inspected, dents removed, split seams resoldered, and all pipes will be bench voiced and regulated.
 Casework.  The existing casework will be cleaned, repaired, and returned to its original configuration with the main flat of façade pipes located above the impost above the keydesk.  If the organ is to be installed in its new home without the need for casework at the sides, the present casework will be sufficient.  If the organ will require side casework, Buzard has acquired surplus casework from another Felgemaker organ which will be fitted to this instrument.
 Delivery and installation.  After completely setting up the organ in our factory, it will be carefully disassembled and packed for shipment.  The organ will be delivered and installed in its new home, with final tuning and regulation completed on site.  The organ will be guaranteed for ten years from the date of completion of installation, provided that the organ is maintained by Buzard Pipe Organ Builders or its designated representatives during the warranty period.   Price will include all factory work, and the work of our crew on site during installation.  Per diem expenses for the installation crew, plus actual delivery costs for the instrument, will be billed separately.

 Additional options could include:

  • Repainting of the façade pipes.

  • Refinishing of the casework.

  • New blower if necessary.

 Possible tonal enhancements could include:

  • 8’ Trumpet on the Great.

  • 4’ Principal on the Swell.

  • 8’ Violoncello in the Pedal.*

  • 16’ Open Diapason in the Pedal.*

 *Buzard has acquired Felgemaker pipes for these stops.


 Circa 1903 W. W. Kimball Organ - Two Manuals & Pedal - Seven Ranks     



GREAT (Manual I, 61 notes, Enclosed)

8              Open Diapason (17 basses in facade, metal-61 pipes)

8              Dulciana (metal-61 pipes)

8              Oboe (metal-61 pipes) (or 4’ Principal)


SWELL (Manual II, 61 notes, Enclosed with Great)

8              Std. Diapason (wood-61 pipes)

8              Gamba (metal-61 pipes) (or 8’ Oboe)

4              Flute D'Amour (wood and metal-61 pipes)


PEDAL (27 notes)

16            Bourdon (wood-27 pipes)


COUPLERS   Great to Pedal, Swell to Pedal, Swell to Great, Super Octave

ACCESSORIES       Swell Expression Shoe

                                  Crescendo Shoe

DIMENSIONS        Mainframe 100” wide x 67”deep (+ 35” for pedalboard)                       Floor to top of casework posts c.116”

                                Floor to top of tallest façade pipes c.132.5” (this could be                      reduced slightly.)


INQUIRIES             Buzard Pipe Organ Builders, LLC

                                112 West Hill Street, Champaign, IL61820

                                E-mail [email protected]

                                Telephone 800-397-3103



Delaware Unit Organ

We would be pleased to supply a rendering of how this instrument would look in your location! 

Kindly contact Keith Williams, Service Department Director at 217 390 4000.


2 manual and pedal, 6 ranks

Delaware organ

Pedal                                        Manual II                     Manual I

16 Rohr Bourdon                     8 Rohr Flute                 8 Principal

8 Rohr Gedeckt                        8 Gemshorn                8 Rohr Flute

4 Octave                                     4 Rohr Flute                 8 Gemshorn

4 Gemshorn                              4 Gemshorn                4 Octave

2 Principal                                1-1/3 Gems. Quint        4 Rohr Flute

16 Trompette                           8 Trompette                    2 Gemshorn

8 Trompette                                                                        II Mixture

4 Trompette                                                                        8 Trompette

                                                                                               4 Trompette


Electropneumatic action

Console with setter board combination action – 5 General pistons

1/4 hp Laukhuff blower

 Pipework analysis from visual inspection

 16 Bourdon – Chimney Flute                                        CCC +/- 5” scale

16 Trompette                                                               CCC +/- 3-1/2”

4 Principal

4 Gemshorn

II Mixture

 “Enclosure” is 48” deep by c.129” tall

 Main chest is c. 40 x 64

Bourdon chest c.30 x 32